Double probe、double frequency or single probe 、double frequency

Every testing channel /frequency has different warning output

Configure probe connection

Support rotating probe drive

Filter rang is wide,suitable for dynamic testing

Flexible I/O interface connecting to processing controller（PLC）（PLC）

Multiple language user interface

Set and signal tracking can be saved 

Computer software,used for transfer testing result to computer

Application 

Detecting surface cracks on components

Conduct heat treatment classification with round coil or probe 

Detecting nonferrous metal bar 、wire and tube by round coil

Using fixed probe to detect rotating iron or nonferrous metal bar and pipeline

Using fixed probe to detect iron or welding zone of nonferrous metal welded pipeline

Thread detection as well as other test piece characteristics detection

Pathway detection

Colorful display with CCFT back lighting ,the color in every channel is optional

Frequency range 50Hz to 10MHz

Low pass filter 20Hz to 5KHz

High pass filter all pass、unnormal  0.01Hz to 0.5Hz, normally 10Hz to 2KHz

Channel/probe every unit has two, it can support multiple devices synchronous working 

Independent alarm,optional alarm modes are phase position、amplitude or strobe

Alarm delayed time is from 50millisecond to 10 seconds

Alarm delay menu is optional

Balanced standardization independence of each probe or joint calibration,remote balance  standardization

Trace recording/ playback can up to 30 seconds built-in record

Built-in relay alternating current or direct current relay, order specification,providing Amphenol connector on back plate ,matching pieces are provided as attachments

Analog output independence,analog output is optional

Synchronous input by backplate RJ45 connector

Automatic power on user can choose to start up by intranet

working temperature :-15~55℃

saving temperature:-20~60℃

relative humidity: not exceed 85%

working voltage :AV220V/DC24V